1、Choose a suitable site and warehouse

The site or warehouse where the steel is stored should be located in a clean, well-drained area, away from mills and mines that emit harmful gases or dust. Weeds and all debris must be removed from the site to keep the steel clean.

The warehouse can not be stacked with acid, alkali, salt, cement and other corrosive materials of steel. Different grades of steel should be stacked separately to avoid confusion and contact corrosion large materials, rails, steel plates, large diameter steel pipes, forgings, etc. can be stacked outdoors and should be stored in a well-ventilated shed, but some small steel, thin steel plates, steel strips, silicon steel sheets, small diameter or thin-walled steel pipes, various cold... Rolled and cold-drawn steel, as well as expensive and corrosive metal products that can be stored in warehouses, should be selected according to geographical conditions. Doors and windows, as well as warehouses with ventilation devices. Maintain a suitable storage environment

2、 Reasonable shape advanced first

Require stacking by grade and specification, in the case of stable stacking and ensuring safety, different grades of materials should be stacked separately to avoid confusion and mutual corrosion. It is forbidden to store items that cause steel corrosion near the pile, the bottom should be high, strong and flat to avoid deformation of materials by moisture, and the same materials should be stacked separately according to the order of entry to facilitate the implementation of the "first-in-first-out" principle. Tend to facilitate drainage, pay attention to put material straight, to prevent bending deformation, there is a certain channel, maintenance channel is generally 0.5m, channel channel depending on the size of the material and transport equipment. The general height of the bottom of the pile is 1.5~2.0m, if the warehouse is on the cement ground of the sun, the height of 0.1m is

enough, if it is mud, it must be raised 0.2~0.5m, if it is open ground, it must be raised the cement ground.
0%26 points; 3~0%26 points; 5m, in the outdoor with 0.5~0.7m high sand mud platform laid angle and channel steel, should be laid, that is, the mouth facing down, I-beam vertical placement, steel surface I-slot should not face up, in order to avoid water corrosion. (Chongqing Meida, Germany Saar, mold steel)